Tonearm Adaptor for Origin Live & Rega (Old Threaded Base Only) to Allow Mounting to Linn Geometry Armboards
Tonearm Adaptor mount for Origin Live and Rega arms. This is suitible for use on Linn armboards 4mm thick and above.
This mount can also be used for fitting Origin Live arms to armboards thicker than 28mm as the arm is clamped up with a grub screw in the side, instead of the usual nut on the threaded base.
Tonearm Adaptor for Origin Live & Rega (Old Threaded Base Only) to Allow Mounting to Linn Geometry Armboards
Linn Mount Fitting Instructions: https://www.originlive.com/wp-content/uploads/2021/01/Linn-Mount-Adaptor-clamp-sleeve-assembly.pdf
The mount works by fitting the outer black disc to your armboard. The arm is then inserted through the silver collar and clamped in tight using a grub screw in the side of the collar (accessed through the small side hole you see in the photo)
Note that the mount is 13mm in height and this should be taken into account when determining it's suitability.
Photo showing top view and how the black disc mount can be fitted from on top using M3 or M4 bolts or screws.
To enable this you will need to drill into the M5 tapped holes in the underside with a 4mm drill to make them into through holes.
Photo showing underside of mount
